Mold removal may be necessary after a flood.

The American Society of Safety Engineers’ (ASSE) warns that mold grows easily in flood-related conditions, which include standing water, humid air and wet surfaces.

The longer these conditions remain, as in the current flooding in the South and the Midwest, the more the mold growth can spread. To address this, ASSE offers the following tips for people to consider when looking at how to clean up mold and minimize its adverse effects.

Be prepared for the worst case scenario

The U.S. Environmental Protection Agency (EPA) recommends that ‘surfaces wet longer than 48 hours with “clean water” should be considered as potentially contaminated, and any surfaces in contact with “dirty water” should be considered contaminated’.

Be aware of local laws and regulations in your area concerning mold, and ask local experts for guidance.

Take steps to protect your business or store from mold growth

In addition, to lessen the chances of a mold colony growing in a store/business, the U.S. Centers for Disease Control (CDC) recommends that

1) the humidity level be kept below 50 percent;

2) an air conditioner or dehumidifier be used during humid months (depending on the climate);

3) adequate ventilation, including exhaust fans, in the kitchen and bathrooms, be used;

4) to add mold inhibitors to paints before applying them;

5) bathrooms be cleaned with mold-killing products; and,

6) not to put carpeting in bathrooms, basements, or other areas where moisture or water could be a concern.

Learn how to recognize mold and be aware of the health risks

Mold, ASSE members note, is a group of microscopic fungi, which also includes mildew and other organisms that rot materials on which they grow. Molds can often be invisible to the eye. A blotch of black, gray, white, red, orange, yellow, blue or violet fuzzy or slimy growth is usually the result of widespread mold growth.

Besides infection and allergic reactions, excessive mold growth indoors can result in offensive, musty odors from the gases released by certain molds as they grow and die.

Clean up the mold

ASSE offers the following tips for cleaning a facility/building area affected by mold:

  • Avoid direct contact with affected mold areas as much as possible.
  • If it can be thrown away, throw it away. Replacements may be less expensive in the long term (and short term) than attempting to decontaminate some surfaces.
  • If it cannot be disposed of, decontaminate and then dry as thoroughly as possible. Moisture removal is a key factor to preventing future growth.
  • Wallboard can often be cut to the point of contamination and replaced with new sections.
  • Clean all tools after use, or dispose if possible, and also clean tools after each shift.
  • When in doubt about the structural integrity of a facility, obtain an evaluation by a licensed and qualified builder or structural engineer before entering. Medical clearance may also be necessary based upon the severity of mold in the area.
  • Individuals involved in mold remediation should be aware that attempts to mix chemicals to clean surfaces can cause further damage, such as the toxic gases that can be released when ammonia and bleach are mixed. Workers need to exercise caution, so as not to create additional hazards. The power supply (circuit breakers) should be turned off in the specific damaged areas/ high levels of moisture to avoid electrical shock hazards.

Source: Cherokeean Herald

Concerned about mold in your building?

Electrocorp offers a range of indoor air purification units for mold and asbestos abatement projects to help keep workers and occupants safe during cleanup and to control mold in the future.

Contact us to find out more.

Advertisements